• 5% Boron-containing polyethylene board

    Borated uhmwpe sheet

    5% boron-containing polyethylene sheet is a new type of shielding material made of polyethylene and boron carbide at high temperature molding to replace borax and paraffin. Hydrogen in boron-containing polyethylene sheet can accelerate the absorption of neutrons for absorption of neutrons. The neutron thus acts to shield the neutron radiation. The 5% boron-containing polyethylene plate is easy to install and has good shielding effect. It is widely used in medical military aviation nuclear reaction and industrial radiation shielding.

  • sucker rod guide

    Sucker Rod Guide

    Ultra-high molecular weight polyethylene(UHMWPE) with very superior physical properties.
    Such as very low friction coefficient, good wear resistance;High impact strength, good corrosion resistance, etc.
    As sucker rod guide or call "centralizer", It can effectively solve the problem of joint and eccentric wear of well bore, thus greatly improving the service life of the well, reduce the maintenance cost.
    Good abrasion resistance and corrosion resistance to ensure the sheath often use for a long time do not need to change.
    We processing sucker rod guide (centralizer) for many years, gathered rich experience in design and processing. Accept custom dimensions.

  • Solar Tracker Bearings

    Solar Tracker Bearings

    Solar Tracker Bearings – Finding the Right Polymer Solution
    1.Self lubrication – since the volumes of these bearings tend to be large, it may not always be possible to lubricate the mechanism regularly. In such a case, self-lubricating bearings are ideal.
    2.Lightweight – as mentioned above, solar plants rely on pockets of sunlight in which they can effectively generate energy. Hence, the aim to maximize the output when the plant is functional is critical to the financial viability of the system. One way to do this is to use materials that place as little load on the mechanisms as possible
    3.UV and weather resistant – It goes without saying that any component used in a solar tracker system will be exposed to generous amounts of sunlight. In addition to this, the effects of rain and general weathering would also need to be accommodated. Plants are usually set up with a time horizon of at least 25-30 years. It is reasonable to assume that a good bearing solution will not need replacement during this time frame.
    4.Wear resistance – again, the constant movement of the system entails a wear resistance bearing that will not yield during the life of the plant.
    5.Cost effective – finally, the volume of bearings required in a single plant can be up to 2000 pieces per Mega-watt. This means that cost is also a criterion that must be looked into when designing the same.

  • uhmwpe crane pads

    Outrigger Pads

    UHMWPE Outrigger Pads are an alternative to wood pads due to their superior characteristics and performance which allows them to last longer.

  • Ground Mat

    Ground Mat

    Ground Mat systems can play a vital role on construction sites by providing a safe,solid yet temporary base for cranes,transport vehicles and staging areas.Ground mats from Anyang Ultrahigh are ideal solutions for soft or shifting soils and inadequate sub-grades,because it distributes the weight of extreme loads over an extensive surface area and keeps your equipment out of the mud.

  • Impact bed bar

    Impact bed bar

    Impact bar is used in the loading area of the belt conveyor to replace the traditional cushion rollers. It’s designed to absorb impact loading which will dramatically reduce shock and stress loading to the structure.
    The use of Impact Beds assists the elimination of roller and frame damage in the loading area and effectively reduces belt damage and shock transfer to the conveyor structure. The Bed’s Impact Bars are used to provide a low friction sliding surface between the impact bed and the rubber belt travelling over it. Furthermore, the Impact Bar's rubber backing is designed to absorb impact loads of material on the Bed.